PRODUCTS CENTER
Malta FA series booster pump
Category:
Product Description
FA series booster pump
1. Introduction
1.1. Application
The main products of FA series booster pumps are FA1D67(A), FA1D63, FA1D56(A) and FA1D53(A). Among them, FA1D67(A) type booster pump is matched with steam driven and electric feed water pump sets with 50% capacity of 600 MW unit; FA1D63 type booster pump is matched with steam driven feed water pump set with 50% capacity of 600 MW unit; fa1d56 is used as booster pump (A) Type FA1D53(A) booster pump is matched with steam driven and electric feed water pump units with 50% capacity of 300MW unit or electric feed water pump unit with 30% capacity of 600MW unit; FA1D53(A) type booster pump is matched with steam driven and electric feed water pump sets with 50% capacity of 300MW Unit.
1.2. Model meaning
FA-**-##-&&-@@
FA -- FA series booster pump code
**------Impeller stages
##--------Hydraulic model number
&&----------Impeller outer diameter nominal size (cm)
@@-------------A means forced oil lubrication / no a means non forced oil lubrication
Example: FA1D56 type booster pump indicates that the series code of this type of booster pump is FA. The number of impeller stages is 1, and the hydraulic model number is D. the nominal size of impeller outer diameter is 56cm, and the non forced oil lubrication is adopted.
1.3. Structural features (see Fig. 6-1)

1.3.1. Single stage double suction impeller is adopted
1.3.2. The horizontal inlet and outlet are connected by flange.
1.3.3. It is integrally installed on the rigid structure pump base made of section steel welding
1.3.4. The volute of pump body is horizontally split.
1.3.5. The hydraulic passage is double volute type with symmetrical radial force
1.3.6. Balanced mechanical seal is adopted.
1.3.7. Bearing lubrication: forced oil circulation lubrication is used when radial bearing and thrust bearing are combined, such as fA1D56A. FA1D67A booster pump; when radial bearing and rolling bearing are used, thin oil lubrication is used, such as FA1D67 and FA1D63 booster pumps.
2. Main technical parameters and product appearance
2.1. Main technical parameters and performance curve
The main technical parameters and flow head curves of FA1D56, FA1D63 and FA1D67 booster pumps are shown in Fig. 6-2 ~ Fig. 6-4.

2.2. Product appearance (see Figure 6-5)

3. Selection method
The user provides the specific configuration requirements and technical parameters of the unit.
4. Scope of supply
Booster pump body: including body pipe, base and anchor bolt, etc.