PRODUCTS CENTER
Papua New Guinea Single pipe multi pumps pneumatic conveying syst
Product Description
Single pipe multi pumps dense phase pneumatic conveying system
1. Introduction
1.1. Purpose
The technology is mainly used in dry treatment of fly ash in coal-fired power plant, and widely used in the concentration and transportation of powdery materials in cement, metallurgy, chemical industry and other industries.
1.2. Working principle
The system uses compressed air as the power, and the core equipment is a group of down drawing bin pumps, which makes the powder materials flow in the pipeline in the form of fluid like, so as to achieve the ideal low conveying speed, high ash gas ratio and high conveying capacity.
1.3. Main features
1.3.1. The system adopts group operation mode, and the configuration of bin pump can be 1 ~ 8 sets to form a conveying unit and share one ash conveying pipeline, so as to realize simultaneous feeding and conveying.
1.3.2. The conveying air ash ratio is high, generally up to 25 ~ 45kg / kg
1.3.3. The system output is large, and the output can reach 70 ~ 90t / h for 300MW Coal-fired Units.
1.3.4. It can realize long-distance transportation, and the conveying distance is more than 1500m.
The conveying pressure is low, generally 0.12 ~ 0.25MPa
1.3.6. The conveying speed is low, the initial speed is not more than 5m / s, and the final speed is not more than 15m / s.
1.3.7. Dense phase control valve technology is adopted. According to the principle of automatic adjustment of back pressure, the starting pressure of conveying is always less than the set value; at the same time, because the dense phase regulating valve adjusts the conveying concentration in time, it can effectively prevent the pipeline from blocking.
1.3.8. The system adopts hard seal self compensation feed valve, which is a valve integrating feed and air permeability. The valve plate adopts hard seal and is automatically compensated by built-in spring. It can be opened or closed in the state of ash, so there is no need to set material level switch and pressure switch for each bin pump. As the valve has its own air vent device, there is no need to set a special vent valve on the bin pump. Therefore, compared with other conveying systems, the control points of the system are greatly reduced, and the fault points are reduced by about 30%.
1.3.9. Since the system has no easily blocked components such as fluidizing plate, the air drying equipment can not be set for the air supply, and the air source does not need to be treated.
2. Equipment appearance
See figure 46-1 for equipment outline of single pipe multi pump dense phase pneumatic conveying system
