PRODUCTS CENTER
Papua New Guinea Waste resin catcher
Product Description
Waste resin catcher
1. Introduction
Application 1.1
Waste resin trapper is used to collect small resin discharged normally from water cap of condensate regeneration system equipment, and timely capture normal resin to avoid resin loss when water cap of regeneration equipment is damaged.
1.2 model significance
GF180
G --- filtration
F -- waste resin
180 -- equipment diameter (cm)
1.3 structural features
1.3.1. The inside is stainless steel wire wound filter element.
1.3.2. Anticorrosion of equipment lining glue.
1.4 main technical parameters
The main technical parameters of waste resin trapper are shown in table 70-1
Table 70-1 main technical parameters of waste resin trapper
| Nominal diameter Item |
DN1200 | DN1800 |
| Design pressure (Mpa) | <0.1 | <0.1 |
| Design weight (kg) | 400 | 820 |
| Running load ( N) | 1000 | 1500 |
| Typical application | 300MW, 600MW | 600MW, 1000MW |
2. Equipment appearance and structural dimensions
The shape and structure of waste resin trapper are shown in figure 70-1, table 70-2 and table 70-3

Table 70-2 outline dimensions of waste resin trapper
| Nominal diameter Item |
DN12000 | DN1800 |
| H | 1945 | 1360 |
| H1 | 1400 | 500 |
| L | 569 | 1100 |
Table 70-3 nozzle of waste resin trapper
| Nozzle Code | Usage | Nominal dimensions | |
| DN1200 | DN1800 | ||
| N1 | air exhaust | 150 | 150 |
| N2 | water outlet | NPT3/4 | NPT3/4 |
| N3 | water inlet | 125 | 200 |
| N4 | water outlet | 125 | 200 |
| N5 | air inlet | 50 | 65 |