PRODUCTS CENTER
Tanzania HX series Siphon tank
Category:
Product Description
HX series Siphon tank
1. Introduction
1.1 purpose
The equipment is installed in the high position of the pump inlet, and the water is injected at the initial start-up of the pump to replace the bottom valve.
1.2 model significance
HX45
HX -- siphon
45 -------- equipment diameter (mm)
1.3 structural features
The equipment is made of carbon steel and lined with a layer of 3mm thick rubber plate.
1.4 product series
See table 34-1 for HX siphon tank product series
Table 34-1 main product series of HX siphon tank
| Nominal diameter | Effective volume(m3) | Model | Outline dimensions(mm) | Flange dimensions(mm) | Weight | |||||||||
| (kg) | ||||||||||||||
| (mm) | H | H1 | H2 | H3 | L1 | L2 | DN1 | DN2 | DN3 | DN4 | DN5 | |||
| DN450 | 0.12 | H×45 | 1150 | 81 | 153 | 863 | 331 | 120 | 40 | 150 | 50 | 200 | 40 | 110 |
| DN650 | 0.24 | H×65 | 1250 | 90 | 175 | 981 | 431 | 130 | 50 | 150 | 50 | 200 | 50 | 284 |
2. Technical parameters
The main technical parameters are as follows:
2.1. Siphon height: < 4.5m
2.2. Vacuum degree: < 0.045mpa
2.3. Design temperature: 50 ℃
3. Equipment appearance and structural dimensions
The shape and structural dimensions of HX siphon tank are shown in figure 34-1 and table 34-1.
