全部
  • 全部
  • 产品管理
  • 新闻资讯
  • 介绍内容
  • 企业网点
  • 常见问题
  • 企业视频
  • 企业图册

Product Description

1. Product introduction

CH type steel pulley is widely used in the suspension and movement of cables in the mobile power supply machinery. The device has a strong structure. Flexible movement. Safety and reliability.

CH type pulley is composed of three parts: traction lead-up pulley, cable pulley and terminal block. The traction pulley follows the mobile mechanical cable guide (traction) device, and each mobile machine is equipped with one, which runs back and forth with the mobile machinery. The middle cable trolley suspends the cable within the I-beam track range and moves with the traction pulley. Both ends are equipped with buffer bumpers. The number of blocks depends on the length of the moving. The terminal block is fixed at the end of I-beam guide rail, and generally one for each mobile machine.

The series of blocks are divided into five types: I, II, Ⅲ, IV and V. for example, the users use 12#, 14#, 16#, or bigger size of I-steel

CH cable trolley series is a kind of conductive form which supplies power to crane trolley. It consists of walking wheel, bracket and support plate. It fixed soft cable on the support plate, and the traction frame and cable trolley are synchronized to realize the purpose of power supply for the trolley.

CH series cable pulleys are divided into medium load type, heavy load type and light load type. Therefore, the pulley of the trolley is ∮ 80, ∮ 63, ∮ 50, and the bearing capacity is ≤ 50 ∮ 150kg. Each type is divided into single layer, double layer and three layers according to the number of supporting plate layers. There are three types of each type. The first end is cable traction car, and the terminal is fixed cable hanger, and the middle is cable trolley.

 

2. Installation instructions

2.1. After the fixed wire hanger is installed, a baffle plate shall be hung at the back

2.2. Adjust the lead head so that the trolley does not touch the upper and lower edge of the traction hole during the whole travel.

2.3. The cable length is 1.2 times the operation span plus 8 meters.

2.4. Adjust the traction wire rope to make its length less than the same cable length, and the traction wire rope is stressed during operation.

2.5. When the cable diameter is not equal, rubber shall be padded between cable clamps to make the outer diameter of the cable basically the same, so as to clamp the cable.

2.6. When laying cables, the stress balance of cable tray on both sides shall be considered.

2.7. When cable pulley is two and three layers, the requirements are the same.

2.8. The double washers on the pulley device are adjustment washers. When the guide rail is not suitable, place the washer on the inside of the fixed plate, so that the width and width of the adjustment gauge are manufactured according to the guide rail as I100 * 68 * 4.5, Ⅱ 120 * 74 * 5, I 140 * 80 * 5 and I160 * 88 * 6. Non standard pulley is processed and manufactured according to the drawings.

 

3. Product size

Model A a B H L I R Weight kg
CH-Ⅰ 170 72 195 110 145 110 50 2.84
CH-Ⅱ 240 135 245 120 220 135 60 5.88
CH-Ⅲ 240 135 285 130 260 180 80 7.09
CH-Ⅳ 320 200 315 130 300 200 95 7.33
CH-Ⅴ 420 200 350 150 360 260 120 8.35