PRODUCTS CENTER
Product Description
The grinding roller system is composed of roller frame, roller shaft, roller sleeve, roller core, bearing, oil seal, etc.
The grinding roller is located between the grinding plate and the press frame, and tilts 15 °, and is positioned by the press frame. The roller sleeve is worn on one side during the use. After the wear reaches a certain depth, it can be turned over for use to make reasonable use of the material.
The grinding roller is operated at a higher temperature, and the oil temperature in its inner cavity is high (up to 120 ℃). In order to ensure the bearing is in good use, the synthetic hydrocarbon SHC high temperature bearing gear oil with high viscosity, high viscosity index and high temperature stability is used for lubrication. Each roller is filled with 40 liters of oil. The oil seal is completed by two oil seals. The external environment of the first oil seal and the internal lubricating oil of the second oil seal are used, The two oil seals are filled with high temperature resistant grease to lubricate the lip of the first oil seal.
There are two kinds of bearings in the grinding roller, the big bearing is cylindrical roller bearing, the small bearing is double row radial spherical roller bearing, and the two bearings bear the radial and axial forces of the grinding roller respectively.
The role of roller frame is to transmit the load force through hinge shaft to the grinding roller. It is connected with the sealing air system through the sealing air pipe of the grinding roller. The sealing air flows through the inner cavity of the roller to the outer oil seal of the grinding roller and the air sealing ring between the roller frame. In this case, a clean ring seal is formed to prevent the coal powder from entering and damaging the oil seal, and also has the function of reducing the temperature of the grinding roller.
A respirator is installed at the end of the roller shaft at the roller frame, which makes the sealing air and the internal oil cavity communicate, eliminating the adverse effects under different temperatures and pressures, so as to ensure the normal air pressure and good environment in the oil chamber. The roller shaft is equipped with a measuring oil level detection hole, and screw on the screw plug after use.
Design points of roller grinding section
1. The grinding roller is an important part of the coal mill, and the matching size of each part should be ensured in the design.
2. Calculate the service life of roller bearing and bending stress of roller shaft.
3. Calculate the main parameters of roller diameter and width.
4. Be familiar with the material of roller matrix (Ni-hard IV, high chromium, surfacing composition, performance, etc.).
5. Determine the curvature radius and minimum thickness of roller matrix.
6. The bearing of grinding roller should have large oil gap.
7. Pay attention to the direction of roller support guard plate (the direction of static and rotating nozzle ring guard plate is different).
8. The temperature measuring thermal resistance of grinding roller shall be standard. If it cannot be installed (the protection box is long), the technical conditions shall be specified.
9. The technical requirements describe the grinding mode of thermal resistance temperature measuring wire.
1. The technical requirements indicate that the pressure test shall be carried out after the assembly, the test pressure is 0.2MPa, the pressure is maintained for 30 minutes, and the allowable pressure drop is 0.1MPa.
11. Be familiar with the assembly relationship of grinding roller department.
12. Familiar with roller oil (mobilshc634 industrial lubricant), high temperature oil.
: next page