PRODUCTS CENTER
Malta BQ01 type booster pump
Category:
Product Description
QB01 booster pump
1. Introduction
1.1. Application
BQ01 type booster pump is mainly used as booster pump between Deaerator and feed water pump in power plant to ensure the inlet pressure required by boiler feed water pump and make it reach enough NPSH, thus reducing the installation height of deaerator.
1.2. Structural features
BQ01 type booster pump is a single-stage single suction centrifugal pump with volute casing, axial suction and radial discharge. The motor drives the impeller shaft to rotate through the laminated flexible coupling. One end of the shaft is supported by roller bearing and the other end is equipped with impeller. The impeller is made of stainless steel and has a balance hole on it to balance the axial thrust. In front of the impeller, there is a cross shaped guide plate in the inlet mouth, so that the water does not pre rotate when entering the impeller, so that the head can be increased and the effective NPSH of the boiler feed pump can be increased.
Oil is installed in the bearing frame to lubricate the bearing (the oil pool equipped with cooling pipe is used for cooling). The oil level is monitored through the oil window, and the oil seal is sealed by rubber with framework. The shaft seal is a mechanical seal with flexible graphite as packing. The outer cooling sleeve is cooled by water. The cooling ring is installed between the pump shell and the bearing. The cooling water is passed through the cooling ring, so that the heat of the pump does not affect the bearing, so as to ensure the normal operation of the bearing.
The sliding pin expansion system with transverse and longitudinal connection is adopted for the connection between pump shell and base, so as to ensure the neutral of the pump after thermal expansion.
2. Main technical parameters and product appearance
2.1 main technical parameters
2.1.1. Typical technical parameters (see table 8-1)
Table 8-1 typical technical parameters of BQ01 booster pump
| Item | Parameters |
| Inlet flow(m3/h) | 758.4 |
| Medium temperature(℃) | 170 |
| Density(kg/m3) | 897.3 |
| Head (m) | 90 |
| NPSH required (m) | 5 |
| Speed(r/min) | 1500 |
| Efficiency (%) | 80 |
| Shaft power (Kw) | 205 |
2.1.2. Parameter curve (see Figure 8-1)

2.2. Product appearance (see Fig. 8-2 ~ Fig. 8-4)

3. Scope of supply
3.1. Booster pump body: including bottom plate (shared with motor), anchor bolt and pad iron, water pipe and oil pipe of main body.
3.2. Inlet filter of booster pump.
3.3. Coupling (motor booster pump).
3.4. Auxiliary motor for booster pump.
3.5. Spare parts: including dynamic and static rings of mechanical seals, bearings, etc. (supplied on demand).