全部
  • 全部
  • 产品管理
  • 新闻资讯
  • 介绍内容
  • 企业网点
  • 常见问题
  • 企业视频
  • 企业图册

Product Description

Powder resin filter

 

1. Introduction

1.1 purpose

Powdered resin filter is used in the condensate polishing system of air cooling unit to remove metal corrosion products (mainly iron oxide), colloidal silica and suspended impurities in the system, as well as some soluble salts.

1.2 model significance

                         FG180

                         F -- powder resin

                         G ------ filtration

                         180 -------- equipment diameter (CM)

1.3 structural features

1.3.1. The structure of large flange is convenient for disassembly and assembly.

1.3.2. The filter element is fixed in a special cage structure.

1.3.3. Anticorrosive coating shall be applied inside the equipment.

1.3.4. Wire wound filter element or melt blown filter element that can be coated with membrane shall be used.

1.4 main technical parameters

See table 46-1 for main technical parameters of powder resin filter

Table 46-1 main technical parameters of DN 1300 powder resin filter

Desgin pressuer (Mpa) 3.5
Desgin capacity(t/h) 490
filter elment flux(m3/h) 2.5
No. of filter element(PCS) 196
Design weight(kg) 4440
Running load(N) 10000
Typical application(MW) Air cooling unit

Note: the filter elements used are based on grafer melt blown filter elements of USA.

 

2. Equipment appearance and structural dimensions

The outline structure of powder resin filter is shown in figure 46-1 and table 46-2

Table 46-2 orifice table of DN 1300 powder resin filter

Nozzle code Application Nominal dimensions(mm)
N1 compressed air inlet 100
N2 outlet 250
N3 upper outlet 125
N4 inlet 125
N5、N6 mirror 80

Note: for larger diameter equipment, prefilter structure can be used as powder resin filter. Only need to install the filter element which can lay the membrane.